Poolease X1 Cordless Robotic Pool Cleaner

Press and hold the red power button on the bottom of the cleaner for three seconds. Lower it gently into the pool within one minute. After it reaches the floor, it waits about five seconds and begins cleaning automatically.

X1 is designed for flat-bottom above-ground frame pools and small in-ground pools up to 960 sq. ft. The maximum supported water depth is 8.2 ft (2.5 m), and the pool-floor slope should remain under 10 degrees.

No. X1 is a pool-floor cleaner. It is not designed to climb walls, clean steps, or scrub the waterline.

A normal X1 cleaning cycle is approximately 100 minutes. Actual runtime and movement can vary with pool shape, floor condition, debris load, and water conditions.

A normal X1 charge takes approximately 2.5 hours. The charging port must be completely dry before connecting the supplied adapter.

When the battery falls below 10%, X1 moves toward the pool wall and parks near the edge. Use the included retrieval hook and then lift the cleaner by its handle. Do not pull it out by the charging cable or adapter.

Open the four body latches, lift off the outer cover, remove the filter, and rinse the filter and chassis with clean water. Check the wheels and impeller for trapped hair or debris before reassembly.

Remove the cleaner from the pool and dry the charging port completely. Remove the silicone plug, connect only the supplied adapter, and reinstall the plug after charging to protect the charging contacts from corrosion.

Clean and dry all parts, store the cleaner in a cool place, and recharge it about every three months. The manual recommends keeping the battery between 40% and 70% during long-term storage.

X1 includes a transferable 12-month limited warranty, including battery coverage, subject to the warranty terms and exclusions. Contact poolease-service@outlook.com for support.